In my search for more interesting filament, today's experiment is Taulman Alloy 910

Since my Mk3 is equipped with an E3D NozzleX, I had to choose my temperatures a bit higher.

Profile: Chris' MK3 Pretty PETG

Filament: 260°C / 265°C

Bed: 45°C

Most importantly: YOU NEED GLUESTICK ON THE BED

Taulman itself has a short paragraph about PEI print beds where they advice against using PEI beds. Otherwise, the print will easily peel off, but I had good experience with generic gluestick on the PEI sheet where it sticks good enough to cause those small bubbles under the PEI sheet.

Even a print with the worst case for warping (slim, long, sharp edges) it adhered well. For now, I'm still looking how to get rid of those discolored / burnt marks. I suspect that thats material sticking to the nozzle which then gets deposited on the part sometimes. Well, the burn marks are from a leaking heating block...

Previous Post Next Post